Peerless-AV HLGP432-C450-SM-Q10 - Installation - Manual (Page 2)

2 of 5 ISSUED: 05-25-10 SHEET #:125-9113-3 09-15-11
Secure four 10-32 brass inserts ( D) into bottom of display base stand using Krazy Glue (C).
NOTE: Do not apply and extensive amount of glue on 10-32 brass inserts (D) or fasteners
will be difficult to fasten. Krazy Glue must be applied as shown in fig. 1.1.
After applying glue, 10-32 brass inserts ( D) must be fully seated into holes in the display base stand.
NOTE: Installer must allow Krazy Glue (C) a minimum of 15 minutes to dry prior to installation on the
swivel plate assembly ( A).
1
D
NOTE: Display stand and mounting
hole locations may appear different than
illustrated.
Attaching Inserts to Display Base Stand
C
D
.09"
FIG 1.1 FIG 1.2
BOTTOM OF DISPLAY BASE STAND