Peerless-AV PRS-EXC-W - Installation - Manual (Page 9)

9 of 13 ISSUED: 04-24-08 SHEET #: 055-9256-9 11-21-11
Installing Projector Mount
4
Installing PRS projector mount with wall installation: Position PRS projector mount (A) to the orientation shown
in fi gure 4.1 and attach to horizontal mounting plate (FF) using two M5 x 16 mm socket pin screws (GG), four fl at
washers (F) and two locknuts (KK).
Installing PRS projector mount with ceiling installation: Attach vertical mounting plate (EE) to PRS projector
mount (A) using two M5 x 16 mm socket pin screws (GG), four fl at washers (F) and two locknuts (KK) as shown in
fi gure 4.2.
NOTE: Placing washer (F) and nut (KK) combination on inside of PRS projector mount fi rst while attaching
mounting bracket (EE or FF) can make installation easier as shown in fi gure 4.3.
fi g. 4.1 fi g. 4.2
fi g. 4.3
PLACE WASHER (F) AND
NUT (KK) COMBINATION
FIRST
KK
F
A
5
Ceiling installation: Insert vertical mounting plate (EE) into inner channel (CC) with projector mount (A) in the
correct orientation shown in fi gure 5.1. Secure vertical mounting plate to inner channel using four socket pin screws
(JJ) as shown in fi gure 5.2.
fi g. 5.1
CC
EE
ARROW
INDICATES
FRONT OF
MOUNT
A
fi g. 5.2
JJ
EE
CC
GG
EE
ARROW INDICATES
FRONT OF MOUNT
CEILING INSTALLATION
A
F
KK
F
WALL INSTALLATION
(EXCEPT FOR EXC MODELS)
KK
F
GG
FF
A
F
ARROW INDICATES
FRONT OF MOUNT