Peerless-AV PS-1 - Installation - Manual (Page 6)

6 of 6 ISSUED: 07-03-02 SHEET #: 200-9386-6 01-25-11
Visit the Peerless Web Site at www.peerlessindustries.com For customer service call 1-800-729-0307 or 708-865-8870.
Depending on the specific size & weight of the plasma, plasma may appear to lean sideways. Pitch roll assembly (D)
allows plasma to be manually adjusted, so plasma can be horizontal. To adjust, gently rotate plasma by hand to desired
position.
IMPORTANT! Center bolt is factory torqued for optimal performance to adjust for range of plasma sizes.
If it is too difficult to adjust roll of plasma, torque may be adjusted by following the procedures below.
Adjust tilt adjustment knob (G) to allow maximum tilt.
Insert 3/4" open-end wrench (not provided) into side of pitch roll assembly (D) and rotate center bolt counter-
clockwise to loosen torque.
IMPORTANT! Do not loosen or tighten more than 1/8 turn.
CENTER
BOLT
PLASMA
A
D
ADAPTER
PLATE
PLASMA
D
CENTER
BOLT
WRENCH
G
NOTE: Refer to page four of accompanying instruction sheet for attachment of PS 1 with plasma to wall
plate before proceeding with step 4.
© 2004 Peerless Industries, Inc. All rights reserved.
Peerless is a registered trademark of Peerless Industries, Inc.
All other brand and product names are trademarks or registered trademarks of their respective owners.