Peerless-AV PS-1 - Installation - Manual (Page 5)

5 of 6 ISSUED: 07-03-02 SHEET #: 200-9386-6 01-25-11
Visit the Peerless Web Site at www.peerlessindustries.com For customer service call 1-800-729-0307 or 708-865-8870.
Insert two M10 penta-pin screws (F) into rotation box
(A) as shown. Leave approx. 1/4” of exposed thread.
Hook pitch roll assembly (D) onto M10 penta-pin screws (F). Insert carraige bolt (E) into slot
of tilt pivot retainer assembly (B) as shown. Install tilt adjustment knob (G).
Install remaining two M10 penta-pin screws (F). HAND TIGHTEN all four M10 penta-pin
screws (F) to allow for tilt adjustment. Remove tape from carriage bolt (E). For tilt adjustment,
gently push back on the top of plasma to relieve pressure on knob. Adjust tilt to desired
position and tighten tilt adjustment knob (G), then securely tighten all four M10 screws (F)
using penta-pin driver (K).
AS A FINAL PRECAUTION, CHECK ALL FASTENERS AND TIGHTEN SECURELY.
A
D
B
E F
F
G G
.25"
F
E
F
• Always use an assistant or mechanical lifting equip-
ment to safely lift and position the plasma television.
WARNING