Peerless-AV PS-1 - Installation - Manual (Page 2)

2 of 6 ISSUED: 07-03-02 SHEET #: 200-9386-6 01-25-11
Visit the Peerless Web Site at www.peerlessindustries.com For customer service call 1-800-729-0307 or 708-865-8870.
M5 SCREW
SLOT
RETAINING
SPACER
BRACKET
VERTICAL
POSITION
OPTIONAL:
PLASMA IN VERTICAL POSITION
HORIZONTAL
POSITION
TILT BRACKET
BRACKET
M5 SCREWS
CENTER
BOLT
Insert and tape carraige bolt (E) into top hole
of pitch roll assembly (D). Attach pitch roll
assembly (D) to adapter bracket with four M10
penta-pin screws (F). Tighten M10 screws
with penta-pin driver (K).
Note: Adapter bracket may be ordered
separately and will vary in size and style.
D
GENERIC
ADAPTER
BRACKET
TILT BRACKET
CENTER
BOLT
GENERIC ADAPTER BRACKET
RETAINING
SPACER
WASHER
SLOT
M5 SCREW
BRACKET
CARRIAGE BOLT
DETAIL 4
DO NOT REMOVE M5 SCREWS. For vertical orientation,
unscrew two M5 screws until screw is able to move
freely in slot of tilt bracket as shown in details 4 and 4A.
Hold adapter bracket stationary and rotate tilt bracket
90° by hand or using a lever (example: wood 2 x 4).
Align M5 screws with threaded holes on bracket and
tighten two M5 screws back into bracket.
E
DETAIL 4A
M5 SCREW WASHER
THREADED
HOLE
F
GENERIC
ADAPTER
BRACKET
NOTE: Refer to adapter plate instruction sheet (not included
with PS-1) for attachment of adapter plate to plasma before
proceeding with step 2.
• Do not overtighten screws. Overtightening may hinder
roll option.
CAUTION