Warning, Caution, Fig. 4.1 fig. 4.2 – Peerless-AV HP432 - Installation User Manual

Page 4: Ca swivel restriction 4, Mounting using non-security, Mounting using security slop nuts (optional), Mounting to support surface

ISSUED: 08-1-12 SHEET #: 090-9125-10

4 of 6

Visit the Peerless Web Site at www.peerless-av.com For customer care call 1-800 865-2112

• Make sure that the supporting surface will safely support the combined load of the equipment and all attached

hardware and components

WARNING

fig. 4.1

fig. 4.2

60°

120°

LoCK At 0°

Refer to fig. 4.1 and 4.2, select the desired swivel degree. Using a 3/32" allen wrench, fasten two set screws (

where indicated below to the outside of desired angle in steel base (

C).

Note: Set screws (K) must be bottomed out into base.

Swivel Restriction

180°

240°

210°

40°

30°

210°

Mounting using Non-Security....................................................................

Step 5 Page 5

CAUtIoN

• Installations to desktops that have a gap between two supporting boards are not acceptable mounting surfaces

for the HP line of desktop swivel mounts.

Mounting using Security Slop Nuts (Optional) .......................................

Step 7 Page 5

Mounting to Support Surface

FRoNt