Peerless-AV HP432 - Installation - Manual (Page 3)

ISSUED: 08-1-12 SHEET #: 090-9125-10 3 of 6
Visit the Peerless Web Site at www.peerless-av.com For customer care call 1-800 865-2112
Turn base ( C) upside down insert support tube (A),
and thrust washer ( F) as shown below.
A
C
F
fig. 3.1
2 3
If the desk thickness is 3/4" use 1/4-20 x 1.5"
threaded rods ( L). If the desk thickness is between
3/4" to 2-3/8" use 1/4-20 x 3" threaded rods ( M).
Turn base ( C) upside down and insert four threaded
rods ( L or M) into base (C), as shown below. Note:
Threaded rods must fasten a minimum of three
turns.
Note: If enhanced security is desired, use three
drops of loc-tite 271 thread lock adhesive ( P) along
1/4" at the end of each threaded rod. Insert adhesive
end of threaded rods ( L or M) into bottom of base
( C).
L or M
C
fig. 2.1
• Wooden mounting surface requires a minimum of 3/4" thickness to hold screen securely.
WARNING
1
Use base backer plate ( B) as a template to mark location of holes. Drill four holes using a 17/64'' drill bit in a
square formation. In the center of the square formation drill 2" to 3" cord management hole.
B
SQUARe FoRMAtIoN
CoRD MANAGeMeNt
CUt-oUt FRoNt oF SCReeN
BottoM VIeW