Peerless-AV PS-2 - Installation - Manual (Page 4)

4 of 6 ISSUED: 08-28-02 SHEET #: 200-9417-3 12-02-04
Visit the Peerless Web Site at www.peerlessindustries.com For customer service call 1-800-729-0307 or 708-865-8870.
L
J
For Concrete Walls drill four 1/4" (6mm) dia. holes to a
minimum depth of 2.5" (64mm) on marks made in step
1. Insert anchor (M) in holes flush with wall as shown
(right). Place wall plate (L) over anchor and secure with
four #14 x 2.5" (6mm x 65mm) wood screws and
washers (O & N) as shown at bottom of page. Make sure
wall plate is level before placing fasteners. Tighten all
fasteners.
CUT
A
W
A
Y
VIEW
1
3
2
Drill holes and insert anchors (M) in four places
Level wall plate and tighten four screws (O).
Place wall plate (L) over anchors (M) and fasten
with screws (O) and washers (N). Do not tighten.
concrete
N
O L
M
M
Attach wall arm assembly (J) to wall plate (L) using
four M10 penta-pin screws (F).
O
L
O
N
F
• Always attach concrete expansion anchors directly to
load-bearing concrete.
• Never attach concrete expansion anchors to concrete
covered with plaster, drywall, or other finishing material.
WARNING
• Tighten wood screws so that wall plate is firmly
attached, but do not overtighten. Overtightening can
damage screws, greatly reducing their holding power.
• Never tighten in excess of 80 in • lb (9 N.M.).
WARNING