Peerless-AV PS-2 - Installation - Manual (Page 2)

2 of 6 ISSUED: 08-28-02 SHEET #: 200-9417-3 12-02-04
Visit the Peerless Web Site at www.peerlessindustries.com For customer service call 1-800-729-0307 or 708-865-8870.
M5 SCREW
SLOT
RETAINING
SPACER
BRACKET
VERTICAL
POSITION
OPTIONAL:
PLASMA IN VERTICAL POSITION
HORIZONTAL
POSITION
TILT BRACKET
BRACKET
M5 SCREWS
CENTER
BOLT
Insert and tape carraige bolt (E) into top hole of pitch roll
assembly (D). Attach pitch roll assembly (D) to adapter
bracket with four M10 penta-pin screws (F). Tighten M10
screws with penta-pin driver (K).
Note: Adapter bracket may be ordered separately and
will vary in size and style.
D
GENERIC
ADAPTER
BRACKET
TILT BRACKET
CENTER
BOLT
GENERIC ADAPTER BRACKET
RETAINING
SPACER
WASHER
SLOT
M5 SCREW
BRACKET
CARRIAGE BOLT
DETAIL 4
DO NOT REMOVE M5 SCREWS. For vertical orientation, unscrew
two M5 screws until screw is able to move freely in slot of tilt
bracket as shown in details 4 and 4A. Hold adapter bracket
stationary and rotate tilt bracket 90° by hand or using a lever
(example: wood 2 x 4). Align M5 screws with threaded holes on
bracket and tighten two M5 screws back into bracket.
E
DETAIL 4A
M5 SCREW WASHER
THREADED
HOLE
F
GENERIC
ADAPTER
BRACKET
NOTE: Refer to adapter plate instruction sheet (not
included with PS-1) for attachment of adapter plate to
plasma before proceeding with step 2.
• Do not overtighten screws! Overtightening may hinder
roll option.
WARNING