Peerless-AV ST16D - Installation - Manual (Page 9)

9 of 11 ISSUED: 09-15-05 SHEET #: 202-9031-3 08-18-11
Mounting and Removing Flat Panel Screen
Hook tilt bracket assembly (A) onto wall plate (B). Then slowly swing screen in as shown. To lock the screen down,
tighten security screw to wall plate using security allen wrench (F) as shown in detail 1.
If mount is attached to double wood stud, solid concrete, or cinder block wall, screen can be adjusted horizontally if
desired. If mount is attached to single wood stud wall, screen must be centered on wall plate (B).
To remove screen from mount, loosen security screws, swing screen away from mount, and lift screen off of mount.
DETAIL 1
SECURITY
SCREWS
B
B
A
A
3
• Always use an assistant or mechanical lifting equipment to safely lift and position the plasma television.
WARNING