Peerless-AV ST16D - Installation - Manual (Page 2)

2 of 11 ISSUED: 09-15-05 SHEET #: 202-9031-3 08-18-11
Note: Read entire instruction sheet before you start installation and assembly.
Tools Needed for Assembly
• stud fi nder ("edge to edge" stud fi nder is recommended)
• phillips screwdriver
• drill
• 5/16" bit for concrete and cinder block wall
• 5/32" bit for wood stud wall
• level
• 6 mm allen wrench
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please
call Peerless customer care at 1-800-865-2112.
• This product should only be installed by a qualifi ed professional.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
• Never exceed the Maximum Load Capacity of 200 lb (91 kg).
• If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of
an "edge to edge" stud fi nder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws fi rmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
WARNING
Table of Contents
Parts List.................................................................................................................................................................................3
Installation to Single Stud Wall ...............................................................................................................................................4
Installation to Double Wood Stud Wall ...................................................................................................................................5
Installation to Solid Concrete or Cinder Block ........................................................................................................................6
Attaching PLP Adapter Plate to Tilt Bracket Assembly ...........................................................................................................7
Attaching LC Adapter Plate to Tilt Bracket Assembly .............................................................................................................8
Mounting and Removing Flat Panel Screen ...........................................................................................................................9
Adjusting the Tilt Angle of the Flat Panel Screen................................................................................................................. 10
Accessories
• Metal Stud Fastener Kit (ACC 415)