Peerless-AV HLG440-LG-Q10 - Installation - Manual (Page 7)

ISSUED: 12-13-10 SHEET #: 090-9197-7 08-18-13
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.
7 of 8
Attach lock-down plate ( A) to bottom of display base
using screws provided ( B and C). Refer to step 2
details 1 and 2 for mounting hole locations.
Note: Remove existing rubber feet from display base
that interfere with the lock-down plate.
Note: Display base stand and mounting hole locations may
appear different than illustrated.
DISPLAY BASE STAND
3
37LD350C HOLE PATTERN SHOWN
B
C
DISPLAY BASE STAND
C
B
Attach lock-down plate to bottom of display base
using screws provided ( B and C). Refer to
lock-down plate/ display base stand hole pattern
at beginning of this step.
Note: Remove existing outside rubber feet from
display base and position them on top of inner
rubber feet as shown.
For Models: 37LH200, 37LH250, 37LH260, 42LH200,
42LH250, 42LH260
Attaching lock-down plate
e
D
FIG 4.1
Mounting Lock down Slope Nuts
Detail 3
tIGHteNING
SLoPe NUt (G)
F
5/8" OPEN BOX
WReNCH
tIGHteNING
SLoPe NUt (F)
D
D
F
Detail 1
Detail 2
F
Hand tighten slope nuts ( F) onto
two of the 1/4-20 x 1 3/4" screw
bolt ( D) until snug against bottom of
table as shown in Detail 1.
Thread another slope nut ( F)
upside-down, about two turns from
first slope nut ( F) as shown in
Detail 2.
Insert a 5/8
" open box wrench
between both slope nuts ( F) and
tighten
as shown in detail 3.
After slope nut is secure remove
bottom slope nut and add plastic
cap ( e) as shown in figure 4.1.
Repeat with remaining
1/4-20 x 1 3/4" screw bolt ( D).
4
BottoM oF DeSK
BottoM oF DeSK
Note: Avoid jamming both slope nuts (G) together,
doing so may make it difficult to remove slope nut
used for tightening.
After slope nut is secure remove bottom slope nut.
LEAVE SPACE
IN BetWeeN
SLoPe NUtS
A