Peterson VS-R StroboRack - Manual (Page 10)

10
StroboRack
TM
Rear Panel Features (With SR-EX PRO Expander Module Installed)
H. A/C ON/OFF Power Switch – rocker.
I. A/C Power Receptacle - chassis-mounted.
J. Lamp Power On/Off Rocker Switch - chassis-mounted.
K. BNC Power Socket 12V - chassis-mounted for gooseneck lamp.
L. Audio Tones Output - ¼” chassis mounted metal jack on rear panel of StroboRack for audio reference tone output.
M. ¼” TRS** Socket - AA/BB channel select with TRS dual latching footswitch stereo Input ¼” chassis mounted metal jack socket on rear panel of StroboRack.
This is an input for a dual stomp switch which is routed as follows: Tip=Output #1, Ring = Output #2, Sleeve = Ground.
N. ¼” TRS** Socket - mute with single TS* latching footswitch, or mute/preset switch with TRS latching dual footswitch stereo input ¼” chassis mounted metal
jack socket on rear panel of StroboRack. This is an input for a single or dual footswitch which is routed as follows: Tip=Mute, Ring = Preset Change, Sleeve
= Ground.
O. Three Position Slider Switch - position 1 = DI GND, position 2 = Auto GND Detect, position 3 = DI GND LIFT.
P. Male XLR*** Socket – DI/ balanced signal output. This output accepts signal from inputs A & T, except when DI input jack Q is engaged, in which case the
signal from Q takes precedence.
Q. Mono Input - ¼” chassis mounted metal jack on rear panel of StroboRack. This jack is linked directly to the DI output P, and enables the user to connect one
of the outputs with the DI using a patch cord or use the DI for another instrument besides the one being tuned by StroboRack.
R. Mono Output - ¼” chassis mounted metal jack on rear panel of StroboRack. This is the main audio output jack.
Both this output and output S are wired respectively to tip & sleeve of combo input T, in order to facilitate stereo in/out operation. If mono input A is engaged,
combo input T is overridden/ disengaged and input A tip feeds signal to R output only, output S is muted.
S. Mono Output - ¼” chassis mounted metal jack on rear panel of StroboRack connected to ring of combo input T. This output jack is a second output to feed a
second amp or can be patched to DI input jack R, and can also be selectable using a footswitch. If M engages with a dual TRS footswitch, one or both
outputs can be selected (R or S or both).
T. Combo input female XLR, TRS & TS jack - chassis mounted with two Philips screws on rear panel of StroboRack. This jack will function only if front panel
input A is not engaged. This input accepts a regular mono signal, a stereo signal or a balanced signal.
*TS = ¼” Tip-Sleeve - Tip carries signal and Sleeve is ground.
**TRS = ¼” Tip-Ring-Sleeve - Tip and Ring carry two mutually independent signals and Sleeve is common ground.
***XLR = Three Pin Balanced - pin 1 = ground, pin 2 = + and pin 3 = -
.