Pace-Edwards BL Toyota Tundra StepSide - Manual (Page 5)

5 INSTALLATION INSTRUCTIONS
Place the four clamps (Fig. 6A)
over the rail brackets located
on the underside of the rails.
Locate the LOWER groove of
the inner clamp bracket onto
the lip of the rail bracket.
Rotate the outer clamp bracket
clockwise to tighten rail
downward against bed rail.
Tighten bolt securely.
(Adjust pressure against
tailgate by moving rails forward
or backward as needed prior
to fi nal tightening of clamps.)
Repeat for all clamps.
HARDWARE USED:
OUTER & INNER RAIL
CLAMPS x 4
1/4” FLAT WASHER x 4
1/4” LOCK WASHER x 4
RAIL CLAMP BOLT x 4
DO NOT TIGHTEN OVER 120-INCH POUNDS!
RAIL
BRACKET
INNER CLAMP
BRACKET
BOLT, FLAT
WASHER &
LOCK WASHER
OUTER CLAMP
BRACKET
FIG. 6A
STEP 6: INSTALL & FASTEN THE CLAMPS
The electronics box has been pre-mounted to the inside of the canister.
Connect the battery wire harness into the 2-wire plug at the end of the canister (also
connect the optional manual switch harness, if installed at this time)
Attach the Red (positive) and Black (negative) wires to the battery or the truck manufacturers
suggested connection points at this time.
Unit is now ready to operate.
Press the Open button to open cover and press the Close button to shut the cover.
STEP 8: CONNECTING THE ELECTRONICS
HARDWARE USED:
Locate the sweep seals (rubber weather strips) on the rails.
Apply Pace Edwards’ UV Protectant (or 303 brand protectant)
to a rag and wipe the underside of the sweep seal and the top
of the wear strip.
Extend the cover to the tailgate. Use an Allen wrench if
needed to carefully draw out the sweep seal (seal should be
angled outwards toward the cover – not rolled in toward the
bed rail). (Fig. 6A)
Proper care and placement of the sweep seal will ensure
smooth operation of the cover. Alcohol, petroleum based or
silicon-based cleaners such as Armor-All
® should be avoided
and ARE NOT recommended for our covers
STEP 7: LUBRICATING & PLACING THE SWEEP SEALS
RIBBED BLANKET
SWEEP SEAL
WEAR STRIP
RAIL
FIG.6A
2-BUTTON REMOTE
KEY FOB x 2