Pace-Edwards BL Remote Programming (Newer Units) - Manual

ELECTRIC RETRACTABLE TRUCK BED COVER
1. Disconnect the power to the Bedlocker unit. (this can either be done at the battery or at the
canister where the wires come out.)
2. Reconnect the power and immediately push the open button on both remote key fobs.
3. Wait 15 seconds after pushing the buttons and try to operate the unit. (It should operate
normally at this time.)
The Electronics box goes into program mode for 2-3 seconds once power is reconnected. If
power is lost to your truck and the buttons are not programmed within 3 seconds of power
being restored everything should stay as it was. If you fi nd this not to be the case please try
reprogramming it as above.
If you have any problems please call our Technical Support Department.
800.338.3697 x331
REMOTE / ELECTRONICS BOX PROGRAMMING INSTRUCTIONS
ELECTRIC RETRACTABLE TRUCK BED COVER
1. Disconnect the power to the Bedlocker unit. (this can either be done at the battery or at the
canister where the wires come out.)
2. Reconnect the power and immediately push the open button on both remote key fobs.
3. Wait 15 seconds after pushing the buttons and try to operate the unit. (It should operate
normally at this time.)
The Electronics box goes into program mode for 2-3 seconds once power is reconnected. If
power is lost to your truck and the buttons are not programmed within 3 seconds of power
being restored everything should stay as it was. If you fi nd this not to be the case please try
reprogramming it as above.
If you have any problems please call our Technical Support Department.
800.338.3697 x331
REMOTE / ELECTRONICS BOX PROGRAMMING INSTRUCTIONS