Step 5: install channel, Step 4: installing rails – Pace-Edwards BL Toyota Tundra StepSide User Manual
Page 4
BEDLOCKER
®
TOYOTA TUNDRA SS
4
STEP 5: INSTALL CHANNEL
Peel the foam backing and attach it to the bottom of the channel.
Bolt the Canister Channel assembly to the rails using the Black #10-32 x 3/4” Flat head
Screw provided. (Figure 5A & 5B)
Black #10-32 x 3/4”
Flat head Screw
Rail
Canister
Channel
#10 Washer
#10-32 Nut
Closed Cell
Foam
Truck
Bed Sill
Canister Channel
Completed Assembly
HARDWARE USED:
CLOSE CELL FOAM x 1
#10-32 x 3/4” FLAT HEAD
SCREW x 2
#10 FLAT WASHER x 2
#10-32 NUT x 2
Canister
STEP 4: INSTALLING RAILS
The machined end of the rail attaches to the
canister.
You will need to lift the hanging portion of the
ribbed blanket and thread it in the rail while
sliding the rail into the rail grip mounted to the
ends of the canister (the underside of the
blanket ribs need to nest on the gear).
Make sure both fl anges of rail slide into the rail
grip.
Rail Grips
Rail
Flange
Ribbed
Blanket
Push the rails forward against the canister.
Complete for both left and right rails.
Remove the support or stand and lower the canister and rail assembly onto the front sill and
rails of the truck bed.
Slide the entire canister and rail assembly forward against the cab end of the truck bed.
Close the tailgate and pull the rails only toward it leaving approximately 1/8” gap between the
end of the rails and the tailgate.
Be sure to hold the canister in place to ensure it does not move from the front truck bed sill
with the rails while adjusting the gap of the rails to the tailgate.