Pace-Edwards 2004-Current BL Ford Flareside Clamp Supplement - Manual

1. To level the rails it is necessary to add a shim
between the rail and the front bed sill. (Figure 1)
1. Looking at the underside of the rail and truck bed rail, locate the factory open slot in the truck bed rail.
2. Install the clamps through these slots in the truck bed. (Figure 2)
3. Hold the rail down and the clamp up while tightening the bolts in the clamps. Do Not Over Tighten.
(Figure 3)
Figure 1
Figure 2 Figure 3
To level the rail, add a
shim between the rail and
the front bed sill.
Be sure to hold the rail down and the clamp
up while tightening the bolts in the clamps.
This will insure a snug fi r to the Truck bed.
Do Not Over Tighten the Clamps
.
COMPLETED ASSEMBLY
BOLT
OUTER RAIL
CLAMP
TRUCK BED
THROUGH SLOT
IN TRUCK
NUT
LOCK WASHER
FLAT WASHER
INNER RAIL
CLAMP
FLAT WASHER
If you have any questions please call our technical
support at:
800-338-3697
2004 - Current
FORD FLARESIDE
RAIL & CLAMP SUPPLEMENT INSTRUCTIONS
LEVELING THE RAILS:
INSTALLING THE RAIL CLAMPS:
04- Current Ford Flareside Rail & Clamp Supplement 056