Pace-Edwards Electric Retractable Utility Bed - Manual (Page 8)

8 ELECTRIC RETRACTABLE UTILITY BED COVER INSTALLATION INSTRUCTIONS
Temporarily remove the end cap screws. (Figure 9A)
Slide the clamps on the vertical rail and secure into place with
the allen wrench and set screw. (Figures 9B & 9C)
Match Drill the Vertical Rail clamps to the truck body. (Figure
9D)
Add shims as needed then secure the vertical rail clamps with
your partner on one side you on the other. (Figure 9E)
Secure the Vertical rail stop strip to the corner blanket guide.
with the #6-32-⅜ STOP STRIP CORNER SCREW (Figure
9F)
Reinstall the end cap screws in both sides. (Figure 9A)
9. INSTALL VERTICAL RAIL CLAMPS
Fig. 9A
Fig. 9B Fig. 9C
Fig. 9D
Fig. 9E
Fig. 9F