Pace-Edwards Electric Retractable Utility Bed - Manual (Page 11)

HELPFUL MAINTENANCE HINTS
To assure quiet, smooth operation, apply a small amount of grease to the guide strips where the metal end of
the panels and the guide strips meet. This initial application should be suffi cient for a year or more. Regrease the
guide strips if the cover begins squeaking during use.
Drain tubes may become clogged over time and should be removed and cleaned.
Periodically remove the top cover and clean out the canister.
To help keep the tonneau cover looking its best, we recommend washing it the same as caring for your truck
fi nish.
If you have any questions please call our Technical Support at (800) 338-3697.
14. INSTALLING THE OPTIONAL MANUAL OPERATION SWITCH
Route the (Optional) Manual Operation Switch wiring through the fi rewall of the truck and pull the harness into
the cab.
Coil the excess wire harness and tie out of the way.
Drill and mount the switch bracket at a convenient position under the dash.
Snap the rocker switch into the switch bracket.
Place ground wire onto center post of rocker switch and attach opposite end to a ground.
Crimp the female spade connectors to the Grey and Purple wires.
Attach the crimped wire to the remaining switch posts.
(If cover runs in opposite direction than you prefer, just switch the Grey and Purple wires) .
Your Utility Bed Cover should run at this time. Check for correct operation by operating all switches installed.
(Part #
BL1120)
ELECTRIC RETRACTABLE UTILITY BED COVER INSTALLATION INSTRUCTIONS 11