Pace-Edwards Utility Rig Rack - Manual (Page 4)

STEP 1: INSTALL SIDE STOPS
HARDWARE USED:
UTILITY RIG RACK 4
NOTE: To prevent Side Stops from the possibility of rattling, inject some silicone sealant
into the T-slot of the gusset before inserting Side Stop.
SIDE STOPS x 4
GUSSET x 4
STEP 2: ASSEMBLE LEGS & GUSSETS
HARDWARE USED: Install gussets into legs as shown until holes align, then slide the 5” carriage bolts through
the holes. Install the 3/8” lock nuts on the 5” carriage bolts and tighten with a 9/16” wrench
until they bear lightly (do not tighten yet) on the aluminum surface.
LEGS x 4
5” CARRIAGE BOLTS x 4
3/8” LOCK NUTS x 4
STEP 3: ASSEMBLE CROSSMEMBERS
HARDWARE USED:
Slide a rubber anti-wear insert into the forward T-slot of each crossmember and slide a plastic
low-friction insert into the REAR T-slot on the REAR crossmember. Slide 2 small carriage
bolts (to be used for braces) into the T-slot on the underside of each crossmember.
1” CARRIAGE BOLTS x 4
TRUSS CROSS-
MEMBER (x2)
REAR CROSSMEMBER
TRUSS PLASTIC LOW
FRICTION INSERT (x1)
CROSSMEMBER
TRUSS RUBBER ANTI-
WEAR INSERTS (x2)
Plastic insert goes in REAR
T-slot of REAR truss ONLY!