Pace-Edwards Utility Rig Rack - Manual (Page 3)

INSTALLATION INSTRUCTIONS
UTILITY RIG LEG BOX CONTENTS:
3
TRUSS MOUNTS (x4)
UTILITY RIG CROSSMEMBER BOX CONTENTS:
5/16” STAINLESS
LOCK WASHERS
(x16) 1” CARRIAGE
BOLTS (x16) 3/8” LOCK NUT (x12)
TRUSS MOUNTS (x4)
5” CARRIAGE BOLTS (x 12)
LEGS (x4) BRACES (x 4) GUSSETS (x 4)
5/16” STAINLESS
LOCK NUTS (x16)
TRUSS CROSSMEMBER (x2) REAR CROSSMEMBER TRUSS
PLASTIC LOW FRICTION INSERT (x1)
CROSSMEMBER TRUSS RUBBER
ANTI-WEAR INSERTS (x2) 3/8” KNOB (x2) SIDE STOPS (x4)
A General Note on Assembly:
These parts have been precision cut to tolerances as close as one thousandth of an
inch. Some fi ts are designed to be press fi ts, others are designed to be sliding fi ts; but
nowhere should the use of great force be required for assembly. As with any piece
of machined equipment, if a part is not fi tting as it should, don’t use excessive force,
identify the problem and correct it. An initial misalignment of two parts can cause a burr
on one of them and make smooth assembly diffi cult.