B&B Electronics 00-00085 - Manual - Manual (Page 5)

User Guide
1
Introduction
This manual is intended to assist IT professionals install the USB Rover
1650/2650. The instructions in this guide assume a general knowledge of
computer installation procedures, familiarity with cabling requirements, and
some understanding of USB devices.
NOTE : Notes give additional information that could make installation
easier.
Product Contents
When you open your product for the first time you should find the following
items:
• USB Rover 1650/2650 User Guide
• LEX unit
• REX unit
• USB cable (2m long)
To complete the installation, you will also require the following items that
are not included with the product:
• USB compatible computer
• USB device
• Category 5 Unshielded Twisted Pair (UTP) cable with two RJ45
connectors (if using surface cabling),
OR,
Category 5 UTP cabling with two information outlets and two
Category 5 UTP patch cords with RJ45 connectors (if using
premise cabling)
NOTE : The maximum length of the Category 5 UTP cable, including patch
cords, must not exceed 50 meters.