B&B Electronics GW-7553 - Quick Start Guide - Manual (Page 3)

on
The connection is error with PROFIBUS Master device or
PROFIBUS system configuration is not correct.
off
PROFIBUS system configuration is correct.
It is normal operation.
on
Data exchange mode.
It is normal operation.
RUN
off GW-7553 module is not in data exchange mode.
3. Establish connection with GW-7553
Before establish the connection between DP-Master and GW-7553, users
should obey the following steps first.
1. First, users must load the
electronic device description file
(GSD file) of the GW-7553 into
the DP-Master.
2. And then set the parameters and
configurations.
3. Finally change your DP-master
from offline state to operate
state. The GW-7553 will be
initialized. If there is no error
occurs, GW-7553 proceeds into
data exchange state. At the
meantime, if there is any error
occurs, GW-7553 will return to
wait for parameterization.
4. Software configuration
GSD file
Please copy the GSD file (IPDS0C0D.gsd) and the bitmap file (ICP_7553.
bmp, GW_7553.bmp) from the CD of the GW-7553 module into the Profibus
configuration tool.
File->CopyGSD
(Directory: --> CD:\profibus\gateway\gw-7553\gsd\)
¾ the example of how to load GSD file
Here, we use the hilscher CIF50-PB PROFIBUS communication interface to
show how to load GW-7553’s GSD file step by step.
GW-7553 PROFIBUS/Modbus TCP Gateway Quick Start (Version 1.00, DEC/2008) PAGE：3