B&B Electronics 00-00169_170_174_194 - Manual - Manual (Page 5)

4
Installation guide
Before you can install the Rover 200, you need to prepare your site.
1. Determine where the computer is to be located and set up the computer.
2. Determine where you want to locate the USB device.
Installing the LEX unit
1. Place the LEX unit near the host computer.
2. Plug the Type A connector from the LEX unit into the USB port on the computer.
Installing the REX unit
1. Place the REX unit near the USB device.
2. Plug the AC adapter into an available AC outlet. Connect the DC power cord to the REX unit.
Connecting the LEX unit to the REX unit
1. Switch on the computer and check that the AC adapter is powered on.
2. Depending on the operating system you are using, open the Device Manager dialog box.
3. Expand the entry labeled Universal Serial Bus Controllers.
4. In the expanded entries you should find one for a Generic USB Hub.
Connecting a USB Device
1. Install any software required to operate the USB device. Refer to the documentation for this device, as
required.
2. Connect the USB device to the USB port on the REX unit.
Compatibility
The USB Rover complies with USB 1.1 specifications governing the design of full-speed and low-speed
USB devices. However, Icron Technologies Corporation does not guarantee that all USB 1.1 devices are
compatible with the USB Rover.
USB extension up to 40m fibre optics