B&B Electronics HDV100A3 - Manual - Manual (Page 3)

HDV100A3 Command & Response Manual Table of Contents i
B&B Electronics -- 707 Dayton Rd. -- PO Box 1040 -- Ottawa, IL 61350
PH (815) 433-5100 -- FAX (815) 433-5104
Table of Contents
INTRODUCTION ........................................................................................ 1
OPERATION ............................................................................................... 1
Command Protocol ................................................................................ 2
Formatting the Control Bytes ................................................................. 3
DETAILED DESCRIPTION OF GENERAL FUNCTION CODES ....... 4
Command Acknowledgement ................................................................. 4
RS-232 Baud Rate Setup ........................................................................ 5
Setting Baud 1, Baud 2........................................................................... 7
Baud Rate Example ................................................................................ 8
Time Stamp Information ......................................................................... 9
Master Reset Command ....................................................................... 11
Vendor Information .............................................................................. 11
J1708 COMMANDS .................................................................................. 12
Receiving Data from the J1708 Bus ..................................................... 12
Transmitting Data to the J1708 Bus .................................................... 14
Set Filter Active .................................................................................... 15
Set Filter Off......................................................................................... 16
Broadcast Message .............................................................................. 17
J1939 COMMANDS .................................................................................. 19
Start Receive on J1939 Bus .................................................................. 20
Stop Receive on J1939 Bus .................................................................. 20
Arbitration Field (Y1, Y2, Y3, Y4) ........................................................ 21
Transmit Data to J1939 Bus ................................................................ 23
Set Mask ............................................................................................... 23
Set Filter 1 to 4 .................................................................................... 24
J1939 Header Worksheet ..................................................................... 26
ERROR CODES ........................................................................................ 27