B&B Electronics SS-BLT-100PR - Manual - Manual (Page 9)

8
5 5
Hardware Installation
1. Connect the Bluetooth adapter to COM Port of PC and then to connect DC
power adapter and jack into power outlet and DC-in outlet. You will see the
red LED is going to be on and the green LCD will be blinked.
2. After running the BT RS232 Config Tool and finish configuration. Click the
icon of “Connect” in tool software and press the SET-UP button of the
Bluetooth adapter immediately.
3. The green LED will be turn on. The E-BT232 Bluetooth adapter is active.
There are two types of RS232 devices in field. One is DTE - Data Terminal
Equipment (such as a PC) and the other one is DCE - Data Communication
Equipment (such as a Modem). You can setup your E-BT232 device as what type
of the RS232 device you are going to connect in DTE or DCE mode to work with
it.
At DCE device side meaning is to connect a DTE E-BT232 to the remote DCE
RS232 device (such as a Modem). On the contrary, DTE device side to connect a
DCE E-BT232 to any DTE device, such as a computer device. For example, you
can connect a remote modem with a DTE E-BT232 and meanwhile at PC side,
you can either connect a DCE E-BT232 to it.