If you have trouble – B&B Electronics SL2736-698 - Quick Start Guide User Manual
Page 8
Printed in U.S.A.
Using a DOS Application on a Windows Notebook
If you need to use the S-I/O with a DOS application on a Windows
notebook, in most cases you only need to install the S-I/O for Windows, not
for DOS. Follow these guidelines:
1. Insert the card and install the S-I/O software for the Windows version on
your mobile computer.
2. Open your DOS program and test the S-I/O. If it works properly, go
ahead and use it and ignore the steps below. If the card does not work
properly, continue with the following steps:
3. Remove the card.
4. A screen may report PC Card Removal Detected. Click OK.
5. Reinsert the card.
6. If your program window minimized, click on the taskbar to remaximize
your program window.
If You Have Trouble
Please refer to the setup instructions and “Troubleshooting” section in the
User’s Guide in the Docs folder on the Serial I/O Installation Disc. If
problems persist, contact Socket’s technical support prepared with the
following information:
•
The part number (including Revision level) and serial number of your
card. See the diagram below.
•
The manufacturer, model number, and operating system of your mobile
computer
•
How you tried to correct the problem
To reach Socket’s technical support department:
•
Web
•
Toll-Free
(800)729−1390
•
Direct 510-933-3020
© Copyright 2001 Socket Communications, Inc. The Serial I/O Card and Ruggedized Serial
I/O Card include technology licensed under United States Patent Nos. 4,543,450, 4,603,320,
and 4,972,470.