beautypg.com

Install the software – B&B Electronics SL2736-698 - Quick Start Guide User Manual

Page 6

background image

Install the Software

STEP 2: DOS Notebooks
STEP 3: Windows 9x/Me/2000 Notebooks

Software installation is NOT needed for the following:

Pocket PCs and other Windows CE-based devices

Revision “K” or earlier of the Standard Serial I/O Card when used with
Windows Me/2000

Revision “E” or earlier of the Ruggedized Serial I/O Card when used
with Windows Me/2000

Windows NT 4.0. Read the note for Windows NT 4.0 on the next page.


Windows 9x/Me/2000 Notebooks`
After inserting the card, complete these steps for software installation:

1. The first time you insert the card, a new hardware or device driver

wizard will appear. Insert the Serial I/O Installation Disc into your
notebook and click Next>.

2. Follow the wizard to install the Serial I/O drivers. Make the appropriate

selection below as prompted:
a. Windows 95 — Select Other Locations… and specify your CD drive.
b. Windows 98 — Select Search for a suitable driver for my device. In

the next screen, select CD-ROM drive.

c. Windows Me — Select Specify the location of the driver. In the next

screen, select Search for the best driver for your device and check
Removable Media.

d. Windows 2000 — Select Search for the best driver for your device. In

the next screen, select CD-ROM drive.

3. Follow the remaining instructions until installation is complete.