Safety recommendations, 7 safety recommendations – Rainbow Electronics GT863-PY User Manual
Page 46
GT863-PY Terminal Product Description
80269ST10026a Rev. 0 - 27/09/06
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Right reserved
page 46 of 50
7 SAFETY
RECOMMENDATIONS
READ
CAREFULLY
Be sure the use of this product is allowed in the country and in the environment required. The use
of this product may be dangerous and has to be avoided in the following areas:
• Where it can interfere with other electronic devices in environments such as hospitals,
airports, aircrafts, etc
• Where there is risk of explosion such as gasoline stations, oil refineries, etc
It is responsibility of the user to enforce the country regulation and the specific environment
regulation.
Do not disassemble the product; any mark of tampering will compromise the warranty validity.
We recommend following the instructions of the hardware user guides for a correct wiring of the
product. The product has to be supplied with a stabilized voltage source and the wiring has to be
conforming to the security and fire prevention regulations.
The product has to be handled with care, avoiding any contact with the pins because electrostatic
discharges may damage the product itself. The same cautions have to be taken for the SIM,
checking carefully the instruction for its use. Do not insert or remove the SIM when the product is in
power saving mode.
The system integrator is responsible of the functioning of the final product; therefore, care has to
be taken to the external components of the module, as well as of any project or installation issue,
because the risk of disturbing the GSM network or external devices or having impact on the
security. Should there be any doubt, please refer to the technical documentation and the
regulations in force.
Every module has to be equipped with a proper antenna with specific characteristics. The antenna
has to be installed with care in order to avoid any interference with other electronic devices and
has to guarantee a minimum distance from the people (20 cm). In case of this requirement cannot
be satisfied, the system integrator has to assess the final product against the SAR regulation.
Electronic equipment to be introduced in the market has to be conforming to the related Directives
of the European Community. All the relevant information is available on the European Community’s
website, especially:
• The Directive 1999/5/EC of the European Parliament and of the Council of 9 March 1999
on radio equipment and telecommunications terminal equipment …:
• The Low Voltage Directive (LVD) 73/23/EEC and The Council Directive 89/336/EEC of 3
May 1989 on ... electromagnetic compatibility (EMC Directive) are available at: