Rainbow Electronics MAX5842 - Manual (Page 3)

MAX5842
Quad, 12-Bit, Low-Power, 2-Wire, Serial
Voltage-Output DAC
_______________________________________________________________________________________ 3
ELECTRICAL CHARACTERISTICS (continued)
(V DD = +2.7V to +5.5V, GND = 0, V REF = V DD , R L = 5k Ω, C
L = 200pF, T A = T MIN to T MAX , unless otherwise noted. Typical values are
at V DD = +5V, T A = +25°C.) (Note 1)
PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS
Input Hysteresis
0.05 ✕
V DD
V
Input Leakage Current Digital inputs = 0 or V DD
±0.1 ±1 µA
Input Capacitance 6 pF
DIGITAL OUTPUT (SDA)
Output Logic Low Voltage V OL I SINK = 3mA 0.4 V
Three-State Leakage Current I L Digital inputs = 0 or V DD
±0.1 ±1 µA
Three-State Output Capacitance 6 pF
DYNAMIC PERFORMANCE
Voltage Output Slew Rate SR 0.5 V/µs
Voltage Output Settling Time
To 1/2LSB code 400 hex to C00 hex or C00
hex to 400 hex (Note 5)
4 12 µs
Digital Feedthrough Code = 000 hex, digital inputs from 0 to V DD 0.2 nV-s
Digital-to-Analog Glitch Impulse
Major carry transition (code = 7FF hex to
800 hex and 800 hex to 7FF hex)
12 nV-s
DAC-to-DAC Crosstalk 2.4 nV-s
POWER SUPPLIES
Supply Voltage Range V DD 2.7 5.5 V
All digital inputs at 0 or V DD = 3.6V 230 395
Supply Current with No Load I DD
All digital inputs at 0 or V DD = 5.5V 280 420
µA
Power-Down Supply Current I DDPD All digital inputs at 0 or V DD = 5.5V 0.3 1 µA
TIMING CHARACTERISTICS (FIGURE 1)
Serial Clock Frequency f SCL 0 400 kHz
Bus Free Time Between STOP
and START Conditions
t BUF 1.3 µs
START Condition Hold Time t HD,STA 0.6 µs
SCL Pulse Width Low t LOW 1.3 µs
SCL Pulse Width High t
HIGH
0.6 µs
Repeated START Setup Time t SU,STA 0.6 µs
Data Hold Time t HD,DAT 0 0.9 µs
Data Setup Time t SU,DAT 100 ns
SDA and SCL Receiving Rise
Time
t r (Note 5) 0 300 ns
SDA and SCL Receiving Fall Time t f (Note 5) 0 300 ns
SDA Transmitting Fall Time t f (Note 5)
20 +
0.1C b
250 ns
STOP Condition Setup Time t SU,STO 0.6 µs