RocketFish RF-TVMLPT01 - User Manual - Manual (Page 6)

6 Need help? Call 1-800-620-2790 (U.S. and Canada) or 01-800-926-3010 (Mexico)
RF-TVMLPT01V2 TV Wall Mount
STEP 2 - Option 2: Installing on a solid concrete or concrete block wall
CAUTION: To prevent property damage or personal injury, never drill into mortar between blocks. Mount
wall plate directly onto the concrete surface.
1 Align the wall plate template (I) at the height you determined in the previous step and make sure that it is
level. Tape the wall plate template to the wall, then use a pencil to mark the lag bolt hole locations (2).
Remove the wall plate template.
2 Drill pilot holes to a depth of 3 in. (75 mm) using a 3/8 in. (10 mm) diameter masonry drill bit.
3 Insert the concrete wall anchors (G) into the pilot holes and use a hammer to make sure the anchors are flush
with the concrete surface.
4 Align the wall plate (H) with the anchors, insert the lag bolts (F) through the holes in the TV bracket, then
tighten the lag bolts only until they are firm against the TV bracket.
CAUTION: Avoid potential injuries or property damage!
DO NOT over-tighten the lag bolts ( F ).
You’ll need
3 in
(75 mm)
F (2)
Pencil
Drill
1/2" socket
wrench
Level
G (2)
Hammer
Template (I)
3/8" masonry
drill bit
Wall plate (H)
Tape
Note: Minimum solid concrete
thickness: 8 in. (203 mm)
Minimum concrete block size:
8 x 8 x 16 in. (203 x 203 x 406
mm)
RF-TVMLPT01V2_13-0602_MAN_V4_ENG-GIFs.fm Page 6 Tuesday, July 9, 2013 1:33 PM