RocketFish RF-TVMLPT01 - User Manual - Manual (Page 5)

5 Need help? Call 1-800-620-2790 (U.S. and Canada) or 01-800-926-3010 (Mexico)
RF-TVMLPT01V2 TV Wall Mount
STEP 2 - Option 1: Installing on a wood stud wall
Note: Drywall covering the wall must not exceed 5/8" (16 mm).
1 Locate the stud. Verify the center of the stud with an edge-to-edge stud finder.
2 Align the wall plate template (I) at the height you determined in the previous step and make sure that it is
level. Tape the wall plate template to the wall, then use a pencil to mark the lag bolt hole locations (2) on the
stud centers. Remove the wall plate template.
3 Drill pilot holes to a depth of 3 in. (75 mm) using a 7/32 in. (5.5 mm) diameter drill bit.
4 Align the wall plate (H) with the pilot holes, insert the lag bolts (F) through the holes in the wall plate, then
tighten the lag bolts only until they are firm against the TV bracket.
CAUTION: Avoid potential injuries or property damage!
DO NOT over-tighten the lag bolts ( F ).
You’ll need
3 in
(75 mm)
Edge-to edge
stud finder
F (2)
Pencil
Drill
7/32" wood
drill bit
1/2" socket
wrench
Level Template (I)
Tape
Wall plate (H)
Note: Minimum wood stud
size: Common 2 x 4 in.
(51 x 102 mm).
Nominal 1.5 x 3.5 in.
(38 x 89 mm)
RF-TVMLPT01V2_13-0602_MAN_V4_ENG-GIFs.fm Page 5 Tuesday, July 9, 2013 1:33 PM