Cobalt Digital COMPASS 9216-OE-DM AES_EBU Fiber Audio De-Embedder - Manual (Page 42)

4-14 •••• Menus 9216-OE-DM User Manual •••• (V 1.1)
3. Release SW2 .
This completes the procedure to reset the card parameters to factory default values.
2 — Reference Source
This menu enables you to select where the card will look for a reference. The choices are Frame
Reference 1 (Fr 1), Frame Reference 2 (Fr 2), and Video (Vid). Refer to the section “Reference
Compatibility” for details.
3 — Loss of Input
Use this menu to select what type of video displays at the system’s outputs when the input video signal
is lost or invalid.
4 — Test Pattern
This menu enables you to specify the type of test pattern to output. Note that this setting is not retained
on power down.
5 — Group Select
This menu enables you to select the embedded group before assigning sources to the channels, enabling
the group, and selecting backup sources. This menu is used in conjunction with Menus 6 to E.
6 — Group Enable
Use this menu to determine if the selected group is embedded in the output or not.
7, 8, 9, A — Channel # Source
Use Menus 7 to A to configure the source that is inserted into the embedded group if present. These
menus are used in conjunction with Menu 5 (Group Select). The following are the default values based
on the group selected:
ƒ
Group 1 — When Menu 5 is set to Grp1, the default value of Menu 7 is G1C1.
ƒ Group 2 — When Menu 5 is set to Grp 2, the default value of Menu 8 is G2C2.
ƒ Group 3 — When Menu 5 is set to Grp 3, the default value of Menu 9 is G3C3.
ƒ
Group 4 — When Menu 5 is set to Grp 4, the default value of Menu A is G4C4.
B — AES Select
Use Menu B to specify an AES output to configure. This menu is used in conjunction with Menus C
(Channel A Source) and D (Channel B Source). The default value is AES1.
C — Channel A Source
Use Menu C to select the Channel A source for a specific AES output. This menu is used in
conjunction with Menu B (AES Select). The following are the default values based on the AES
selected:
ƒ When Menu B is set to AES1, the default value of Menu C is G1C1.
ƒ
When Menu B is set to AES2, the default value of Menu C is G1C3.
ƒ When Menu B is set to AES3, the default value of Menu C is G2C1.
ƒ When Menu B is set to AES4, the default value of Menu C is G2C3.