Cobalt Digital COMPASS 9216-OE-DM AES_EBU Fiber Audio De-Embedder - Manual (Page 17)

9216-OE-DM User Manual •••• (V 1.1) Installation •••• 2-3
Installing the 9216-OE-DM
This section outlines how to install a Rear Module in a 20-slot frame. You cannot install the 9216-OE-
DM in a 8310 series or a 8320 series frame.
Caution — Never attempt to look down the barrel of a connected fiber or device
transmitting an optical signal. The transmitted light is not in the visible spectrum and
may cause permanent eye damage. Turn off all laser sources before disconnecting
devices.
Rear Modules for the 9216-OE-DM
When installing the 9216-OE-DM in a 20-slot frame, the RM20-9216-B Full Rear Module is required.
Refer to the section “20-Slot Frame Cabling Overview” for cable designations.
Installing a Rear Module
If the Rear Module is already installed, proceed to the section “Installing the 9216-OE-DM”.
Use the following procedure to install a Rear Module in your 20-slot frame:
1. Locate the card frame slots on the rear of the frame.
2. Remove the Blank Plate from the slot you have chosen for the 9216-OE-DM installation.
3. Remove the dust cap from the Fiber ports on the Rear Module that faces the interior of
the frame. Refer to Figure 2.1 and Figure 2.2 for dust cap locations.
Figure 2.2 Card Connectors Connectors with Dust Caps Removed
4. Install the bottom of the Rear Module in the Module Seating Slot at the base of the
frame’s back plane.
5. Align the top hole of the Rear Module with the screw on the top-edge of the frame back plane.
6. Using a Phillips screwdriver and the supplied screw, fasten the Rear Module to the back
plane of the frame. Do not over tighten.
7. Ensure proper frame cooling and ventilation by having all rear frame slots covered with
Rear Modules or Blank Plates.
This completes the procedure for installing a Rear Module in your 20-slot frame.