Cobalt Digital COMPASS 9216-OE-DM AES_EBU Fiber Audio De-Embedder - Manual (Page 31)

9216-OE-DM User Manual •••• (V 1.1) Menus •••• 4-3
DashBoard Menus for the 9216-OE-DM
This section briefly summarizes the menus, items, and parameters available from the DashBoard
Control System™ for the 9216-OE-DM. Parameters marked with an asterisk (*) are the factory default
values. The DashBoard Control System™ enables you to monitor and control openGear frames and
cards from a computer. DashBoard communicates with other cards in the 20-slot frame through the
Network Controller Card.
Status Tab
Table 4.1 summarizes the Status tab parameters available in DashBoard for the 9216-OE-DM. The
Status tabs provide read-only information such as software revision issue, reference status, input
format, and power consumption.
Table 4.1 Status Tab Items
Menu Item Parameters Description
Product 9216-OE-DM
Supplier Cobalt Digital Inc.
Board Rev ##
Rear Module # Type of rear module in the slot
Board S/N ###### Indicates the card serial number
Software Rev ##.## Indicates the software version
Product
(Read-
only)
Firmware Rev #.### Indicates the firmware version
OK
FPGA load invalid
Incomp I/O Module
Current out of spec
Internal Error
SFP Temp Low
SFP Temp High
SFP Power High
SFP Power Low
HW Status
SFP Not Detected
Indicates the status of the hardware
including the SFP module. Some
messages displayed are dependent on
the settings in the Alarms Enable tab.
Voltage (mV) # Supply Voltage
Hardwar
e (Read-
only)
Current (mA) # Current consumption of card