Cobalt Digital COMPASS 9374-EMDE Quad-Stream SDI – AES – MADI Embedder_De-embedder - Manual (Page 53)

937X-OM (V1.3) 9374-SERIES PRODUCT MANUAL 3-21
Operating Instructions
9374-Series Function Submenu List and Descriptions
(continued)
• Reference Source Select For Reference VITC timecode choice used for Source Priority above, selects
reference VITC source from the choices shown to the left.
• Output Status Display Displays the current content and source being used for the timecode data as
follows:
• Output status OK (in this example, SDI VITC timecode received and
outputted).
• Timecode Insertion button set to Disabled; output insertion disabled.
Note: • If timecode is not available from Source Priority selections
performed, timecode on output reverts to Free Run (internal count)
mode.
• Because the 1’s digit of the display Frames counter goes from 0 to
29, the fractional digit (along with the 1’s digit) indicates frame count
as follows:
0.0 Frame 0
0.1 Frame 1
1.0 Frame 2
1.1 Frame 3
•
•
•
29.1 Frame 59
• Offset Controls Allows the current timecode count to be advanced or delayed on the output
video.
• Offset Advance or Delay selects offset advance or delay.
• Offset Field delays or advances or delays timecode by one field.
• Offset Frame delays or advances or delays timecode by up to 5
frames.
Note: Default settings are null, with both controls set at zero as shown.
Note: • Although the output line drop-down on the controls described below will allow a particular range of choices, the actual
range is automatically clamped (limited) to certain ranges to prevent inadvertent conflict with active picture area
depending on video format. See Considerations Regarding Multiple-Channel SDI (p. 3-8) for more information.
• The card does not check for conflicts on a given line number. Make certain the selected line is available and carrying no
other data.
Table 3-1 9374-Series Function Submenu List — continued