Cobalt Digital COMPASS 9374-EMDE Quad-Stream SDI – AES – MADI Embedder_De-embedder - Manual (Page 15)

937X-OM (V1.3) 9374-SERIES PRODUCT MANUAL 1-11
Introduction
9374-Series Cards Functional Description
User Control Interface
Figure 1-4 shows the user control interface options for the 9374-Series. These
interfaces are individually described below.
Note: All user control interfaces described here are cross-compatible and can oper-
ate together as desired. Where applicable, any control setting change made
using a particular user interface is reflected on any other connected interface.
Figure 1-4 9374-Series User Control Interface
Computer
with NIC
OGCP-9000 Control Panel
or
OGCP-9000/CC Control Panel
20-Slot Frame with MFC-8320-N network
controller card
LAN
In conjunction with a frame equipped
with an MFC-8320-N network
controller card, 9374-Series card can
be remotely controlled over a LAN
Remote Control Panel
Using the Control Panel,
9374-Series card can be
remotely controlled over a LAN
DashBoard™ Remote Control
Using a computer with
DashBoard™ installed,
9374-Series card can be
remotely controlled over a LAN
Note: • To communicate with DashBoard™ or a Remote Control Panel, the frame must have the optional
MFC-8320-N network controller card installed.
• DashBoard™ and the Remote Control Panels provide network control of the 9374-Series as
shown. The value displayed at any time on the card, or via DashBoard™ or a Control Panel is the
actual value as set on the card, with the current value displayed being the actual value as effected
by the card. Parameter changes made by any of these means are universally accepted by the
card (for example, a change made using DashBoard™ controls will change the setting displayed
on both DashBoard™ and a Control Panel; a change made using a Control Panel will similarly
change the setting displayed on the Control Panel and DashBoard™).