Cobalt Digital COMPASS 9275 HD_SD-SDI Analog Audio De-Embedder - Manual (Page 37)

9275-4C / 9275-8C User Manual •••• (V 1.2) Control and Monitoring •••• 4-13
1. Rotate SW2 to 1 . The Four Character Display displays “Fact Def”.
2. Toggle SW3 down and hold for 3 seconds.
3. Release SW3 .
2 — Reference Source
This menu enables you to select where the card will look for a reference. The choices are Frame
Reference 1 (Fr 1), Frame Reference 2 (Fr 2), and Video (Vid). Refer to the section “Reference
Compatibility” for a list of supported formats.
3 — Loss of Input
Use this menu to select what type of video displays at the system’s outputs when the input video signal
is lost or invalid.
4 — Test Pattern
This menu enables you to specify the type of test pattern to output. Note that this setting is not retained
on power down.
5 — Group Select
This menu enables you to select the embedded group before enabling the group, assigning sources to
the channels, and backup sources. This menu is used in conjunction with Menus 6 to E.
6 — Group Enable
Use this menu to determine if the selected group is embedded in the output or not.
7, 8, 9, A — Channel # Source
Use Menus 7 to A to configure the source that is inserted into the embedded group if present. These
menus are used in conjunction with Menu 5 (Group Select). The following are the default values based
on the group selected:
ƒ
Group 1 — When Menu 5 is set to Grp1, the default value of Menu 7 is G1C1.
ƒ Group 2 — When Menu 5 is set to Grp 2, the default value of Menu 8 is G2C2.
ƒ Group 3 — When Menu 5 is set to Grp 3, the default value of Menu 9 is G3C3.
ƒ
Group 4 — When Menu 5 is set to Grp 4, the default value of Menu A is G4C4.