Cobalt Digital COMPASS 9275 HD_SD-SDI Analog Audio De-Embedder - Manual (Page 16)

2-4 •••• Installation 9275-4C / 9275-8C User Manual •••• (V 1.2)
4. Align the top hole of the Rear Module with the screw on the top-edge of the frame back
plane.
5. Using a Phillips screwdriver and the supplied screw, fasten the Rear Module to the back
plane of the frame. Do not over tighten.
6. Ensure proper frame cooling and ventilation by having all rear frame slots covered with
Rear Modules or Blank Plates.
This completes the procedure for installing a Rear Module in your 8300 series frame.
Installing the 9275-4C or 9275-8C
This section outlines how to install the 9275 in a 8300 series frame. Use the following procedure to
install the 9275 in a 8300 series frame:
1. Locate the Rear Module you installed in the procedure “Installing a Rear Module”.
2. Hold the 9275 by the edges and carefully align the card-edges with the slots in the frame.
3. Fully insert the card into the frame until the rear connection plus is properly seated in the
Rear Module.
4. Affix the supplied Rear Module Label to the BNC area of the Rear Module.
This completes the procedure for installing the 9275 in a 8300 series frame.
Cabling for the 9275
9275-4C Cabling Overview
The 9275-4C is used with the following Rear Modules:
ƒ RM20-9275-4C-B Rear Module — Each card occupies one slot and provides one SDI input,
one SDI output, and four analog outputs. (Figure 2.3)
Figure 2.3 Cable Connections for the 9275-4C