Cobalt Digital COMPASS 9275 HD_SD-SDI Analog Audio De-Embedder - Manual (Page 27)

9275-4C / 9275-8C User Manual •••• (V 1.2) Control and Monitoring •••• 4-3
DashBoard Menus for the 9275
This section briefly summarizes the menus, items, and parameters available from the DashBoard
Control System™ for the 9275. Parameters marked with an asterisk (*) are the factory default values.
The DashBoard Control System™ enables you to monitor and control openGear frames and cards from
a computer. DashBoard communicates with other cards in the 8300 series frame through the Network
Controller Card.
Status Tabs
Table 4.1 summarizes the Status tab parameters available in DashBoard for the 9275.
Table 4.1 Status Tab Items
Menu Item Parameters Description
Product
9275-4C
9275-8C
Analog Audio De-Embedder; 4-Ch
Analog Audio De-Embedder; 8-Ch
Supplier Cobalt Digital Inc.
Board Rev ##
Rear Module # Type of rear module in the slot
Board S/N ###### Indicates the card serial number
Software Rev ##.## Indicates the software version
Firmware Rev #.### Indicates the firmware version
Product
(Read-
only)
Daughter Card Type * ## Indicates if a daughter card is installed.
OK
FPGA load invalid
Incomp I/O Module
Current out of spec
HW Status
Internal Error
Indicates any problems with the card
hardware components
Voltage (mV) # Supply Voltage
Current (mA) # Current consumption of card
CPU Headroom # Processing power available
RAM Available #/## On-board processing memory available
Hardware
(Read-
only)
Uptime (h) #
Displays the number of hours since the last
reboot of the card
Hardware
(Read-
only)
Configuration Bank # Storage count
* This field is not available when using a 9275-A.