Cobalt Digital COMPASS 9275 HD_SD-SDI Analog Audio De-Embedder - Manual (Page 15)

9275-4C / 9275-8C User Manual •••• (V 1.2) Installation •••• 2-3
Installing the 9275-4C or 9275-8C
This section outlines how to install a Rear Module in a 8300 series frame. The same procedure applies
regardless of the frame or card type. However, the specific Rear Module you need to install depends on
your application and the openGear frame you are using.
Rear Modules for the 9275-4C
When installing the 9275-4C:
ƒ
20-slot frame — The RM20-9275-4C-B Full Rear Module (R2C-8259) is required.
Rear Modules for the 9275-8C
When installing the 9275-8C:
ƒ 20-slot frame — The RM20-9275-8C-B Full Rear Module (R2C-8259) is required.
Installing a Rear Module
If the Rear Module is already installed, proceed to the section “Installing the 9275”.
Use the following procedure to install the rear module in an 8300 series frame:
1. Locate the card frame slots on the rear of the frame.
2. Remove the Blank Plate from the slot you have chosen for the 9275 installation.
3. Install the bottom of the Rear Module in the Module Seating Slot at the base of the
frame’s back plane. (Figure 2.1)
Figure 2.1 Rear Module Installation in a 8300 Series Frame (9275 not shown)