Daystar KT09130 User Manual
Page 4
Instruction Sheet P11032-02
2008 Daystar Products Intl
Page 4 of 4
Page 4 of 4
Rear instructions sheet.
Rear Bill of Materials
Part No Description Qty
S10967 BLOCK
2
S10958 U-BOLT
4
S10959 NUT
8
S10963 WASHER
8
WARNING
This vehicle has been modified to enhance its performance. The steering, braking and handling of this vehicle will differ from standard passenger cars and trucks,
This vehicle handles differently from an ordinary vehicle in driving conditions which may occur on streets, highways and off road.
Avoid unnecessary abrupt maneuvers, sudden stops, sharp turns and other driving conditions that could cause loss of control, possibly leading to a roll over or other
accident that could result in serious injury or death to driver and passengers. If larger tires are installed the speedometer will read lower than the vehicles actual
speed.
DRIVE WITH CARE, REDUCE SPEED AND WEAR SEAT BELTS AT ALL TIMES.
1. OE SPRING
2. LIFT BLOCK (thick
end to rear of vehicle!)
3. U-BOLT 9/16-18
4. OE U-BOLT PLATE
5. NUT & WASHER
15. Jack up the rear of the truck and place 2 jack stands under the rear frame and lower down and remove
the rear wheels.
16. Place the floor jack under the rear axle and remove the 4 u-bolts and nuts and lower down the axle
enough to fit the lifting blocks into position.
17. IMPORTANT! Note that the lift block is tapered. Position the block on the axle pad so that the thick
end of the block is toward the rear of the vehicle.
18. Install the new u-bolts, washers, and hex nuts. Torque to 95ft-lbs
19. Install the rear wheels and place back on the ground. Torque the lug nuts to factory specifications.
20. Double-check all fasteners for proper clearances and torque specifications.
5
4
3
2
1
IMPORTANT NOTE: The advertised amount of lift that this kit provides and the thickness of the spacers sup-
plied will not be the same! For example, a 2-1/2” lift may only have 1-1/2” thick spacers. The reason for the
difference between the spacer thickness and the amount of lift has to do with suspension geometry. There is a
ratio involved, and it is this ratio that determines the thickness of the spacers. Rest assured, installing the
spacer supplied will result in the proper amount of lift out at the wheel.