Installation steps – Daystar KT09130 User Manual
Page 2
Instruction Sheet P11032-02
2008 Daystar Products Intl
Page 2 of 4
Installation Steps
1. Read all instructions and check bill of materials and tools before beginning.
2. Disconnect the negative battery cable.
3. Place the vehicle on a clean and level surface. Set the parking brake and
place wheel chocks behind the rear wheels. Jack up the front of the vehicle
by the frame with a floor jack and support vehicle at the frame rails with ap-
proved jack stands. NEVER WORK UNDER AN UNSUPPORTED VE-
HICLE.
4. Disconnect the ABS and brake lines from the upper a-arm and spindle
( 10mm and 12mm bolts.)
5. Disconnect the sway bar on both sides at the spindle. ( 17mm bolt. )
6. Remove the upper strut nuts.( 14mm nuts ) You will need to reuse them later.
7. Remove upper ball joint nut ( 19mm nut ) and separate the ball joint from the
spindle by hitting the side of the spindle. DO NOT use a ball joint separator
tool it can damage the ball joint boot.
- KJ09112BK (1 page)
- KJ09113BK-1 (1 page)
- KJ61004BK (1 page)
- KF09112BK (2 pages)
- KA09100BK (6 pages)
- KC09102BK (1 page)
- KJ60003 (1 page)
- KJ04503BK (1 page)
- KJ71043BK (4 pages)
- KT09118BK (1 page)
- KC09122-2 (2 pages)
- KF09102 (1 page)
- KJ60005 (1 page)
- KJ61003 (1 page)
- KT09120BK (4 pages)
- KT09110BK (2 pages)
- KN09107 (2 pages)
- KJ09152BK (1 page)
- KJ02001 (1 page)
- KJ09156BK-2 (4 pages)
- KJ61009BK (1 page)
- KCO9106 (8 pages)
- KG09108 (4 pages)
- KF09108 (4 pages)
- KJ71034TN (8 pages)
- KJ09117BK-2 (1 page)
- KJ61002 (1 page)
- KU70038BK-1 (4 pages)
- KJ61017 (1 page)
- KT09103BK (1 page)
- KJ61005BK (1 page)
- KC09107 (1 page)
- KJ09155BK-2 (4 pages)
- KU70035BK-2 (4 pages)
- KC09121 (2 pages)
- KT09105BK (1 page)
- KJ09153CAMO (6 pages)
- KG09109 (4 pages)
- KU70037BK-1 (4 pages)
- KJ61019BK (1 page)
- KJ09103CAMO (2 pages)
- KJ09123BK-1 (2 pages)
- KF09050 (2 pages)
- KT09116BK (3 pages)
- KT09115-1 (3 pages)