Daystar KJ04520BK User Manual
Page 3

5
Installation steps
1. The tools needed for installation and a list of parts included in the kit are
listed on page 2. Make sure have all of the proper tools and understand these
directions before proceeding.
2. When working 2009 and up 2dr & 4 door model jeep, you will have 2 extra
mounts and 4 extra stud extenders.
3. Place Jeep on a level ground. Open the hood and use a Phillips screw driver
to twist the center of the push pin insert to release and remove the six push
pin fasteners (1), release the lower clips( 3 ) and separate the grille from the
Jeep
and
dis-
connect the electrical connectors ( 4).
4. With a 16mm socket loosen the two nuts at each of the front core support
body mounts, Then with a 18mm socket loosen the bolts at the right and left
sides of frame body mounts. NOTICE: DO NOT remove nuts at this time.
6
6. Slowly raise up the jeep with the jacking block between the jack and the tub of
the jeep, about 4” off the body mounts and place a 4x6 jacking block between
the frame and the jeep tub. Remove one mount at a time.
7. Place thread lock on the stud extenders.( 2 at a time ) Using a 5/8 wrench in-
stall
the
ex-
tenders
on the
body
mount
and
tighten
down.
8. With the extenders tight install the body
mount spacer over the stock mount.
9. With the spacer mount installed. Install the mount into the fame support.
NOTICE: When installing the front grill mount put the 2 studs in grill frame