Warning – Daystar KF09110-2 User Manual
Page 2
2003 Ford Expedition - Rear Coil Spring Spacer Lift Kit
Instruction Sheet P10598-00
2002 Daystar Products International Inc.
www.DaystarWeb.com
Tech Support Contact Info
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71
st
Avenue
Phoenix, AZ 85043
11.
Reinstall the compressed coil spring onto the strut assembly and re-attach the
upper strut mounting plate.
12.
Decompress the coil spring in the strut assembly. Make sure that the spring is
seated correctly into the strut assembly alignment spiral.
13.
Slide the Top Spacer onto the strut assembly.
14.
Install the strut assembly into the strut tower and start the upper three 10mm nuts
with washer (Make sure that the bottom of the strut is aligned as well)
15.
Install the lower strut bolt in the original position that it was removed.
16.
Using the floor jack, raise the lower control arm and connect the upper ball joint
on the upper control arm to the spindle.
17.
Install the rear tires/wheels.
18.
Lower the vehicle onto the ground and tighten the upper strut tower nuts. (3 on
each side)
19.
Torque all bolts to factory specifications. Re-torque all bolts after 500 miles.
WARNING
This vehicle has been modified to enhance its performance.
The steering, braking and handling of this vehicle will differ
from standard passenger cars and trucks; this vehicle handles
differently from an ordinary vehicle in driving conditions which
may occur on streets, highways and off road.
Avoid unnecessary abrupt maneuvers, sudden stops, sharp
turns and other driving conditions that could cause loss of
control, possibly leading to a roll over or other accident that
could result in serious injury or death to driver and passengers.
If larger tires are installed the speedometer will read lower
than the vehicles actual speed.
DRIVE WITH CARE, REDUCE SPEED
AND WEAR SEAT BELTS AT ALL TIMES.
This kit should be installed by a professional mechanic.