Daystar KF09110-2 - Manual

2003 Ford Expedition - Rear Coil Spring Spacer Lift Kit
Instruction Sheet P10598-00
 2002 Daystar Products International Inc.
www.DaystarWeb.com
Tech Support Contact Info
[email protected]
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71
st
Avenue
Phoenix, AZ 85043
Step(s) DO NOT COMBINE WITH ANY OTHER SUSPENSION KIT
1. Layout all parts and check quantities against the Bill of Materials. Completely
read instructions before beginning installation.
2. Jack the rear of the vehicle in accordance to manufacturer recommendation
and support with jack stands, so that the rear two tires are off the ground
3. Remove the rear tires/wheels.
4. Separate the upper ball joint from the spindle. Use a ball joint separator or
other suitable tool.
5. Remove upper strut nuts on the strut tower (3) on each side of vehicle that
holds strut assembly to the strut tower (Fig. 2).
(Hint: Leave one nut on to prevent the strut from dropping out in the next step.)
6. Remove the lower strut bolt from the lower control arm and remove the strut
assembly from the vehicle. (Note the direction of the bolt for reinstallation)
CAUTION: THE STRUT ASSEMBLY WILL DROP A LITTLE
7. Compress the coil spring on the strut assembly with a suitable coil spring
compressor and remove the upper strut isolator mount nut.
8. Remove the compressed coil spring assembly from the strut.
9. Remove the coil spring isolator from the strut mounting plate.
10. Install the new Coil Spring Spacer to the upper strut mounting plate (Fig. 3).
(Continued on back)
Tools required
Description: Qty.
Wrench set &
Socket set
1
Coil Spring
Compressor
1
Floor Jack 1
Jack Stand 2+
Bill of Materials
Part No. Description Qty
M03458
REAR Coil Spring
Spacer
2
Fig 2.
Fig 1.
Fig 3.