Daystar KF09115BK - Manual (Page 2)

Thank you for choosing Daystar Products
Daystar recommends a certified technician install this system. In addition to
these instructions , professional knowledge of disassemble/reassembly pro-
cedures as well as post instruction checks must be known. Attempts to in-
stall this system without this knowledge and expertise may jeopardize the
integrity and/or operating of the vehicle.
Please read all the instructions before beginning the installation. Check the
kit hardware against the parts list. Be sure you have all the needed parts and
understand where they go. If anything is missing , do not proceed with the
installation, call Daystar Products to obtain needed items.
Product Use Information
As a general rule, the taller a vehicle is the easier it will roll. We strongly recom-
mend , because of rollover possibility, that seat belts and shoulder harness be
worn at all times. Avoid situations where a side rollover may occur.
Braking performance and capabilities are decreased when significantly large/
heavyer tires and wheels are used. Take this into consideration while driving,
also , speedometer recalibration is necessary when larger tires are installed.
Do not add, alter, or fabricate any factory or after-market parts which increase
vehicle height over the intended height of the Daystar Product purchased. Mixing
component brands, lifts, and/or combining body lift with suspension lift voids all
warranties. Daystar makes no claims regarding lifting devices and excludes any
and all implied claims. We will not be responsible for any products that is al-
tered.
Notice to Dealer and Vehicle Owner
Any vehicle equipped with any Daystar Product must have the “Warning to
driver” decal installed on the sun visor or dash. The decal is to act a constant
reminder for whoever is operating the vehicle of its unique handling charac-
teristics. INSTALLING DEALER— Its is your responsibility to install the
warning decal and forward these instructions on to the vehicle owner for
review and to be kept in the vehicle for service life.
After installation occurs, a qualified alignment facility is required to align
the vehicle to factory specs.
14. Tighten the lower strut bolt and nut.
15. Repeat steps 2 threw 15 on other side of the vehicle.
16. After lift has been installed on both side check to see that all
the bolts and nuts are torque to OEM specifications.