Coil spring spacer installation instructions – Daystar KG09117BK User Manual
Page 2

KG09117BK
Coil Spring Spacer Installation Instructions
www.DaystarWeb.com
Tech Support Contact Info
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71
st
Avenue
Phoenix, AZ 85043
19. Assemble all of the components previously removed (sway bar with new polyurethane bushings, tie rod ends with
polyurethane grease boot, brake caliper and anti-lock sensor).
20. Assemble the bushings and sleeves and boots for the front shock absorber. Install the shocks using the factory
hardware at the bottom and the supplied hardware at the top
21. Repeat instructions for other side.
22. After properly installing both spacers you can install your front tires and lower vehicle back to the ground.
23. On the rear, remove the factory shock absorbers but save the hardware for re-use. Assemble the bushings, sleeves,
and shock boots for the rear shock absorbers. Install the rear shocks using the factory hardware.
24. Your vehicle may sit too high at first because the suspension needs to settle. Carefully back the vehicle up and drive
forward a few times using the brakes frequently. Park on level ground and check out your lift.
25. The vehicle will now require a front wheel alignment. Failure to do so may result in severe wear on your tires and may
pull to one direction.
WARNING
This vehicle has been modified to enhance its performance. The steering, braking and handling of this vehicle will differ from
standard passenger cars and trucks, This vehicle handles differently from an ordinary vehicle in driving conditions which may occur
on streets, highways and off road. Avoid unnecessary abrupt maneuvers, sudden stops, sharp turns and other driving conditions
that could cause loss of control, possibly leading to a roll over or other accident that could result in serious injury or death to driver
and passengers. If larger tires are installed the speedometer will read lower than the vehicles actual speed.
DRIVE WITH CARE, REDUCE SPEED AND WEAR SEAT BELTS AT ALL TIMES.
DO NOT COMBINE WITH ANY OTHER SUSPENSION KIT.
This kit should be installed by a professional mechanic.
Instruction sheet P10476-04
Page
2 of 2
© 2006 Daystar Products
International Inc
.