Daystar KN09105 User Manual
Daystar For the car
KN09105 – 2005-2012 Nissan Xterra/Frontier 2" Lift
Instruction Sheet - P11074-02
Page 1 of 2
© 20116 Daystar Products International Inc.
www.DaystarWeb.com
Tech Support:
Phone: 623.907.0081 / Fax: 623.907.0088
841 South 71
st
Avenue; Phoenix, AZ 85043
INSTALLATION INSTRUCTIONS
(Not to be used with a lifted or altered suspension)
1. Read instructions completely, verify bill of materials and determine if you have the correct tools
before beginning installation.
Front Installation
2. Raise vehicle until front tires are clear, support the vehicle.
3. Remove the front tire and wheel assembly.
4. Remove the lower stabilizer link bolt and move sway-bar assembly out of way.
5. Remove the upper ball joint nut.
6. Separate the upper ball joint from the spindle.
7. Remove upper strut nuts on the strut tower(3) on each side of the vehicle that holds the strut
assembly to the strut tower ( Hint: Leave one nut on to provent the strut from dropping out in the
next step.)
8. Remove lower strut bolt from the lower control arm and remove the strut assembly from vehicle.
(Note the direction of the bolt for reinstallation)
9. Install the 3 stud extenders with the M20463 spacer on top of the strut assembly.
10. Install the strut assembly and start the upper three 10mm buts and washer.
11. Install the lower strut bolt in the original position that it was removed.
12. Using he floor jack, raise the lower control arm and connect the upper ball joint on the upper
control arm to the spindle. Torque per OEM specifications.
13. Reconnect the sway bar end links.
Bill of Materials
Part #
Description
Qty
S11014
SHACKLES (REAR)
2
M03678
SPRING BUSHING
4
M03679
SPRING BUSHING
4
S11010
STEEL TUBING 0.584X0.750X3.950
2
S11011
STEEL TUBING 0.584X0.750X2.865
2
S10205
9/16-12 NYLOCK NUTS
4
S10199
9/16-12 X 4-1/2" GR5 GREASABLE BOLT
2
S10388
9/16-12 X 5-1/2" GR5 GREASABLE BOLT
2
S11015
9/16 SAE NARROW WASHER
8
M20463
STRUT SPACER (FRONT)
2
S11134
STUD EXTENDERS
6
S10077
7/16 SAE NARROW WASHER (FRONT)
6
Tools required
Description:
Standard sockets, hand tools Etc.
Hydraulic Lift is Recommended
Floor Jacks / Jack Stands
Ball joint separator
Shown above: S Model with KN09105 2” lift and 32X10.50X16 BFG AT’s