Daystar KF09119BK User Manual

Page 3

NOTICE; Use caution when using spring compressor to remove
coil spring CAUTION: Spring will be under extreme pressure

7. Compress spring down, install new isolator on top of factiory

isolater pat on the top of spring and reinstall spring.

8. Repeat steps 6 and 7 for other side.

9. Lift axle back up and install shocks, brake line bracket Fig.1 ,

2 and 3 and reconnect sway bar endlinks.

Fig 1

Fig 2

Fig 3

Fig 4

shock

Sway bar

Brake line bracket

Spring Compressor

Daystar® Lifetime GoEverywhere Limited Warranty

Your Daystar® Comfort Ride or Budget Boost leveling kit is covered by the
following Go Everywhere Lifetime Limited Warranty provided exclusively

10. Then then double check the installation. Fig. 4
11. Reinstall driver and passenger tires and wheels.
12. Remove jack stands and lower the truck back on the ground.

Remove all jacks and jack stands from under vehicle.

13. Torque the lug nuts to 85ft.lbs. using an X pattern.
Center the steering wheel.
!Caution: Have an alignment professional check and adjust the
alignment to factory specifications.
14. With the vehicle on the ground cycle the steering wheel side to

side and inspect suspension components, brake lines and tires to
ensure there are not any clearance issues. Jounce the suspension
to assure front suspension operates freely, brake lines retain
proper slack at full extension and that they remain clear of
springs or other obstructions.

15. Install “Warning to Driver” decal on the vehicle’s sun visor or

dash. The decal must be placed in a conspicuous location. Any-
one that operates the vehicle must be made aware of the chang-
es made.

16. After 25 miles of driving re-torque the lug nuts to 85 ft.lbs..
17. After 500 miles of driving re-torque all of the hardware associ-